AXP340 long delay for Press Alt at startup

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Recent problem with my AXP340.   Was fine for past year or so....
Most days, on first flight of the day, I don't get Pressure altitude output for 10 minutes or so.  It starts in ALT mode and transponder squawk works fine, but The AXP screen shows Pressure Altitude shows FL---.  After 10 minutes or so, the AXP340 starts reporting the correct Press Alt.

This started a few weeks ago.  No recent panel work done.

Any troubleshooting suggestions?

Joe Brunski
1977 C-177RG with two IFD540s + AXP340 + MLB100

Edited by CardinalRG - 12 Nov 2016 at 12:01pm

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
CardinalRG Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 02 Aug 2015 Location: Canada Status: Offline Points: 12	Post Options Post Reply Quote CardinalRG Report Post Thanks(0) Quote Reply Topic: AXP340 long delay for Press Alt at startup Posted: 12 Nov 2016 at 11:44am
	Recent problem with my AXP340. Was fine for past year or so.... Most days, on first flight of the day, I don't get Pressure altitude output for 10 minutes or so. It starts in ALT mode and transponder squawk works fine, but The AXP screen shows Pressure Altitude shows FL---. After 10 minutes or so, the AXP340 starts reporting the correct Press Alt. This started a few weeks ago. No recent panel work done. Any troubleshooting suggestions? Joe Brunski 1977 C-177RG with two IFD540s + AXP340 + MLB100 Edited by CardinalRG - 12 Nov 2016 at 12:01pm

DavidBunin Members Profile Send Private Message Find Members Posts Add to Buddy List Senior Member Joined: 20 May 2015 Location: Rockwall, TX Status: Offline Points: 742	Post Options Post Reply Quote DavidBunin Report Post Thanks(0) Quote Reply Posted: 18 Nov 2016 at 3:08am
	Sounds like the heater is going out in your altitude encoder. Altitude encoders normally contain a heater to bring the pressure sensor to an above-ambient operating temperature (usually around 140°F) which means they can eliminate temperature as a variable in the pressure sensor logic. Most encoders have a warm-up time of no more than 30 seconds before they go valid. Have your altitude encoder removed and bench tested at an avionics shop. My guess is you'll be buying a new one. They are not terribly expensive. David Bunin