|
AXP340 Configuration 6.1.13 p22 |
Post Reply 
|
| Author | |
Gary T 
Groupie 
Joined: 13 Nov 2013 Location: Michigan Status: Offline Points: 80 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: AXP340 Configuration 6.1.13 p22Posted: 11 Nov 2014 at 11:39am |
|
On p. 22 of the AXP340 installation manual, section 6.1.13, the configuration choices are either
1090ES ADS-B TIS-B receiver or UAT receiver or none. If I use my portable Clarity ADS-B receiver (receives both 1090ES TIS-B and UAT TIS-B signals), what is the configuration setting to program into the AXP340? My dealer programmed no 1090Es and no UAT ADS-B receivers since I have no TSO approved ADS-B permanent mount receivers installed.
|
|
|
Gary-T
|
|
 |
|
|
Gary T
Groupie
Joined: 13 Nov 2013 Location: Michigan Status: Offline Points: 80 |
Post Options
Thanks(0)
Quote Reply
Posted: 11 Nov 2014 at 12:07pm |
|
From the Clarity ADS-B website FAQ:
To receive all ADS-B In services from the ADS-B ground infrastructure, aircraft must broadcast valid ADS-B Out messages that indicate their ADS-B-In capability.
|
|
|
Gary-T
|
|
|
|
|
ddgates
Senior Member 
Joined: 12 Aug 2011 Location: Deer Valley Status: Offline Points: 1100 |
Post Options
Thanks(0)
Quote Reply
Posted: 11 Nov 2014 at 5:15pm |
|
John Collins queried the FAA on this topic, and has a letter back from them basically saying if you have an approved ADS-B out device (e.g. AXXP 340), and ANY in device (be it a GDL38, Stratus, or whatever), the intent is to provide the traffic data, and thus it is permissible to indicate that you DO have ADS-B in capability (that is, IN for these purposes doesn't have to be panel mount, or TSO).
I have a copy of the letter somewhere, in fact shared with my shop as they were insisting on the same logic your shop is. Good luck. |
|
|
David Gates
|
|
|
|
|
ddgates
Senior Member
Joined: 12 Aug 2011 Location: Deer Valley Status: Offline Points: 1100 |
Post Options
Thanks(0)
Quote Reply
Posted: 11 Nov 2014 at 5:17pm |
Edit: I have a PDF of the letter I reference. |
|
|
David Gates
|
|
|
|
|
Gary T
Groupie
Joined: 13 Nov 2013 Location: Michigan Status: Offline Points: 80 |
Post Options
Thanks(0)
Quote Reply
Posted: 11 Nov 2014 at 6:19pm |
|
David,
Would you be able to email me your PDF letter to Skylane8@aol.com? Is John Collins a forum member or Avidyne employee? Thank you for this information. Gary
|
|
|
Gary-T
|
|
|
|
|
SB Jim
Senior Member
Joined: 30 Aug 2012 Location: Santa Barbara Status: Offline Points: 211 |
Post Options
Thanks(0)
Quote Reply
Posted: 12 Nov 2014 at 3:24am |
|
Neither.
John Collins owns and flies a V-tail Bonanza. He formerly owned an avionics shop. He's very knowledgeable on avionics related issues and writes for the American Bonanza Society magazine. Edited by SB Jim - 12 Nov 2014 at 3:24am |
|
|
|
|
Gary T
Groupie
Joined: 13 Nov 2013 Location: Michigan Status: Offline Points: 80 |
Post Options
Thanks(0)
Quote Reply
Posted: 12 Nov 2014 at 3:51am |
|
Thank you for the reply/information. After my first flight (Monday) with my AXP340/IFD540 I sent an email to : and I received their response (compliance report) this morning. Requested report attached. Everything looks good. The small issue flagged with Geo Alt was while the aircraft was on the ground so your system checks out good.
|
|
|
Gary-T
|
|
|
|
|
ddgates
Senior Member
Joined: 12 Aug 2011 Location: Deer Valley Status: Offline Points: 1100 |
Post Options
Thanks(0)
Quote Reply
Posted: 12 Nov 2014 at 4:16am |
sent. DMG |
|
|
David Gates
|
|
|
|
|
ddgates
Senior Member
Joined: 12 Aug 2011 Location: Deer Valley Status: Offline Points: 1100 |
Post Options
Thanks(0)
Quote Reply
Posted: 12 Nov 2014 at 4:17am |
Got the same for my recent install. |
|
|
David Gates
|
|
|
|
|
chflyer
Senior Member
Joined: 24 Jan 2013 Location: LSZK Status: Offline Points: 1078 |
Post Options
Thanks(0)
Quote Reply
Posted: 12 Nov 2014 at 5:44am |
|
What did you attach to your email to the FAA? This there a place on the FAA site that shows what they want to see as input for their compliance check?
|
|
|
Vince
|
|
|
|
|
pburger
Senior Member
Joined: 26 Dec 2013 Location: United States Status: Offline Points: 406 |
Post Options
Thanks(0)
Quote Reply
Posted: 12 Nov 2014 at 6:07am |
|
chflyer,
You don't attach anything. It's a real world test, not some paperwork review. You have to have flown with the new equipment such that your ADS-B pings were being received. You then send the e-mail to that FAA address, and they pull the logs and based on the data they received, they tell you if your data stream is compliant.
|
|
|
|
|
chflyer
Senior Member
Joined: 24 Jan 2013 Location: LSZK Status: Offline Points: 1078 |
Post Options
Thanks(0)
Quote Reply
Posted: 12 Nov 2014 at 11:38am |
|
Ah, ok. Clear.
|
|
|
Vince
|
|
|
|
|
Gary T
Groupie
Joined: 13 Nov 2013 Location: Michigan Status: Offline Points: 80 |
Post Options
Thanks(0)
Quote Reply
Posted: 12 Nov 2014 at 12:56pm |
|
In the email to the FAA, I mentioned the day I flew, time of day, flight route. Perhaps not necessary?
|
|
|
Gary-T
|
|
|
|
|
Gary T
Groupie
Joined: 13 Nov 2013 Location: Michigan Status: Offline Points: 80 |
Post Options
Thanks(0)
Quote Reply
Posted: 12 Nov 2014 at 12:59pm |
|
Most important-include your tail number
|
|
|
Gary-T
|
|
|
|
|
MysticCobra
Senior Member
Joined: 29 Jan 2013 Status: Offline Points: 696 |
Post Options
Thanks(0)
Quote Reply
Posted: 12 Nov 2014 at 12:59pm |
Not necessary. Big Brother has all that data in the ADS-B world.
|
|
|
|
|
Post Reply
|
|
| Tweet |
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You can vote in polls in this forum |
Topic Options
ddgates wrote: