Avidyne Homepage
Forum Home Forum Home > Avidyne General > AMX240 Audio Panel
  New Posts New Posts RSS Feed - Dynon + Avidyne IFD
  FAQ FAQ  Forum Search   Register Register  Login Login

Dynon + Avidyne IFD

 Post Reply Post Reply
Author
Message
brennon24 View Drop Down
Newbie
Newbie
Avatar

Joined: 06 Nov 2019
Location: Mississippi
Status: Offline
Points: 5
Post Options Post Options   Thanks (0) Thanks(0)   Quote brennon24 Quote  Post ReplyReply Direct Link To This Post Topic: Dynon + Avidyne IFD
    Posted: 07 Nov 2019 at 5:57pm
Hello, I’m new to the group and thought I might start a new topic. I recently purchased the IFD 440 and DYNON HDX(I have Jeppesen full USA NAV DATA). I have lots of compatibility/crossfill questions but for now.

1. How do you get the VOR to show up on the HDX HSI? (I have tried setting the 440 to VLOC and tapping the gps selector button on the HDX but with no luck)

2. Will the IFD display show instrument approach step down altitudes? I checked on the Dynon forum and as of now, there is no way of displaying step down altitudes on the map display or the flight plan page of the HDX(bummer).

Thanks!


Edited by brennon24 - 07 Nov 2019 at 6:06pm
Back to Top
Flying_Monkey View Drop Down
Groupie
Groupie


Joined: 27 Mar 2017
Location: CA
Status: Offline
Points: 70
Post Options Post Options   Thanks (1) Thanks(1)   Quote Flying_Monkey Quote  Post ReplyReply Direct Link To This Post Posted: 21 Dec 2019 at 12:19pm
You should be able to see the IFD Nav source on the HSI by setting the IFD to VLOC and tapping the HSI source on the Dynon until it says IFD NAV.  You can also go in to MENU, PFD TOOLS and configure.  I made a sort of related video that may help you as it depicts switching nav sources on the HDX....

https://www.youtube.com/watch?v=IbdihdNGp8Y
Back to Top
brennon24 View Drop Down
Newbie
Newbie
Avatar

Joined: 06 Nov 2019
Location: Mississippi
Status: Offline
Points: 5
Post Options Post Options   Thanks (0) Thanks(0)   Quote brennon24 Quote  Post ReplyReply Direct Link To This Post Posted: 23 Dec 2019 at 11:03am
Thanks! I finally found in the PFD MENU that I needed to select an additional bearing pointer. I’m not looking at my unit but I believe that’s what did the trick. Thanks again
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.01
Copyright ©2001-2018 Web Wiz Ltd.

This page was generated in 0.055 seconds.