Two waypoints after activating FPL on approach

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   I’ve noticed this behavior for some time, but was asked a question about it today and didn’t know the answer.

I’m flying a flight plan to a destination airport. Prior to arriving, I add via the PROC key an RNAV approach with an appropriate IAF. I continue to navigate normally, with my next waypoint active, and then a “fence” followed by the first segment of the approach. I have the soft key “activate approach” available.

If I activate the approach, the FPL removes the “fence”, and the resulting flight plan has the current waypoint, followed by the IAF. It then shows the approach, with the first waypoint repeated. The second copy of the waypoint has an altitude restriction, while the first does not.

If I select the second waypoint and activate it, the IFD changes into GPS->LNAV+V. If I do not, when I reach this waypoint, the IFD cycles to the next waypoint in the approach, and the GPS->LNAV+V appears.

Why, when I activate the approach, does it not just sequence to the IAF and arm the GPS->LNAV+V?

Thanks!

P.S. The IAF in this example has an altitude higher than I’m flying at. I don’t know if this is related somehow, just providing it for complete information. 

Edited by Melohn - 3 hours 56 minutes ago at 7:38pm

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Melohn Members Profile Send Private Message Find Members Posts Add to Buddy List Senior Member Joined: 11 Dec 2013 Location: PHNL Status: Offline Points: 145	Post Options Post Reply Quote Melohn Report Post Thanks(0) Quote Reply Topic: Two waypoints after activating FPL on approach Posted: 4 hours 2 minutes ago at 7:32pm
	I’ve noticed this behavior for some time, but was asked a question about it today and didn’t know the answer. I’m flying a flight plan to a destination airport. Prior to arriving, I add via the PROC key an RNAV approach with an appropriate IAF. I continue to navigate normally, with my next waypoint active, and then a “fence” followed by the first segment of the approach. I have the soft key “activate approach” available. If I activate the approach, the FPL removes the “fence”, and the resulting flight plan has the current waypoint, followed by the IAF. It then shows the approach, with the first waypoint repeated. The second copy of the waypoint has an altitude restriction, while the first does not. If I select the second waypoint and activate it, the IFD changes into GPS->LNAV+V. If I do not, when I reach this waypoint, the IFD cycles to the next waypoint in the approach, and the GPS->LNAV+V appears. Why, when I activate the approach, does it not just sequence to the IAF and arm the GPS->LNAV+V? Thanks! P.S. The IAF in this example has an altitude higher than I’m flying at. I don’t know if this is related somehow, just providing it for complete information. Edited by Melohn - 3 hours 56 minutes ago at 7:38pm