Unit sent in for RMA |
Post Reply |
Author | |
Don
Groupie Joined: 21 Jan 2014 Location: Fort Worth Status: Offline Points: 58 |
Post Options
Thanks(0)
Posted: 28 Sep 2015 at 4:11pm |
Hi guys my unit was sent in for hardware upgrade etc.. not sure yet which way it is going to go
My question is my Avionics shop gave me a loaner 540 in the meantime until mine comes back I get a CAS warning to set heading bug to the particular DTK... when set to say 040* on the OBS the 540 doesn't recognize that it is set to 040*... is there a way to calibrate the 540 to the OBS so the CAS message goes away ... it keeps popping up about every two minutes Or is this something done in maintenance mode during install... Thanks
Edited by Don - 28 Sep 2015 at 4:12pm |
|
edanford
Senior Member Joined: 21 Nov 2011 Location: Austin Tx Status: Offline Points: 116 |
Post Options
Thanks(0)
|
That should be Config set up Main CDI / OBS page
Ed |
|
Ed
|
|
AviJake
Admin Group Joined: 26 Mar 2009 Location: Lincoln MA Status: Offline Points: 2815 |
Post Options
Thanks(0)
|
Correct.
|
|
Steve Jacobson
sjacobson@avidyne.com |
|
Don
Groupie Joined: 21 Jan 2014 Location: Fort Worth Status: Offline Points: 58 |
Post Options
Thanks(0)
|
Im on it ... will check it out tomorrow thanks for the help !!!
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |