10.2.4.1 question |
Post Reply |
Author | |
ddgates
Senior Member Joined: 12 Aug 2011 Location: Deer Valley Status: Offline Points: 1100 |
Post Options
Thanks(0)
Posted: 27 Apr 2020 at 10:02am |
There doesn't seem to be a PG specific to 10.2.4.1? Perhaps I missed it.
I'd like more info on: 1. Turning off WiFi ADSB 2. Maintenance password Is there material out there on those topics? Thanks!
|
|
David Gates
|
|
chflyer
Senior Member Joined: 24 Jan 2013 Location: LSZK Status: Offline Points: 1034 |
Post Options
Thanks(0)
|
+1
|
|
Vince
|
|
AviSteve
Admin Group Joined: 12 Feb 2018 Location: Melbourne, FL Status: Offline Points: 2244 |
Post Options
Thanks(0)
|
There is no pilot guide update specifically for 10.2.4.1.
WiFi ADS-B Assuming you are referring to the item on the Setup Page with the title "ADS-B Forwarding". That item is available when the IFD is configured with an ADS-B in device. When the selection is "On", the IFD will send ADS-B In data over WiFi for use by applications such as Foreflight. Maintenance Mode Password Protection PIN Maintenance mode now has the capability to protect settings by requiring a personal identification number (PIN) to be entered before any settings changes will be accepted. When no PIN has been defined, settings can be changed without protection of a PIN. To define a PIN, navigation to the Password Protection PIN page, then press the right knob button. Use the inner and outer knobs to change characters and move the cursor, respectively. Once the desired PIN has been entered, press the right knob to set it. Once the PIN has been set, entry of that PIN will be required to save changes to settings. Note that the IFD will allow settings to be viewed and changed even without entering the current PIN. However, any changes will not be saved unless the PIN has been entered. If the PIN has not been entered, the text "Password - Protected" will be shown in yellow under the page title on any of the pages where settings can normally be changed. Edited by AviSteve - 28 Apr 2020 at 9:26am |
|
Steve Lindsley
Avidyne Engineering |
|
skybum02
Groupie Joined: 11 Dec 2017 Status: Offline Points: 42 |
Post Options
Thanks(0)
|
Steve, I had a problem with the network settings did not save even-though I think changes to the network settings does not require a PIN. I had to get the PIN eradication DSF to reset. It's fixed now. Maybe a glitch in the software. Cheers, Steve
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |